• No se han encontrado resultados

Título60 GHz Millimeter Wave Propagation Inside Bus: Measurement, Modeling, Simulation, and Performance Analysis

N/A
N/A
Protected

Academic year: 2020

Share "Título60 GHz Millimeter Wave Propagation Inside Bus: Measurement, Modeling, Simulation, and Performance Analysis"

Copied!
12
0
0

Texto completo

Loading

Figure

FIGURE 1. Network access during commute.
FIGURE 2. Measurement setup [left]. The bus from outside [right-top] and inside [right-bottom].
FIGURE 3. Placement of the antennas inside the bus [left], photographs of the antenna assemblies [middle], and simulated radiation patterns of the antennas both in the E-plane and in the H-plane [right].
FIGURE 5. CTF phase measured and generated [car data].
+6

Referencias

Documento similar

In the first model (the Theoretical Model), the impact of the existence of innovation on financial performance is potentially mitigated by the extent to which the economic and social

A model for analysis is therefore proposed (Figure 1) to study the financial performance from a two-fold perspective in relation to cost saving and financial resources allocated

a) De finition of the model: a multistep model is proposed based on supervised clustering learning and multivariable regres- sion. The presented methodology enables the

The structure of the paper is as follows: Section 2 presents the vehicle modeling and the combination method for kinematic and dynamic models; Section 3 defines the proposed

Little drawback of the proposed method is rather more time that is necessary to design a simulation model at initial stage of the manufacturing system

When the workers are not able to direct their search to one type of vacancy only, all the workers are in the same market and the matching rates between workers and …rms depend on

The method to emulate the chan- nel model consists of convolving the base band signal to be transmitted with the urban macro-cell or urban micro-cell channel model tap delay

Finally, the main objective of the work is to develop a complete study of the manifold multiplexer, its circuit model optimization and a complete design (from the ideal circuit model