Fault Detection and Diagnosis in a Heat Exchanger Using Dynamic Principal Component Analysis and Diagnostic Observers-Edición Única

 The expansionary monetary policy measures have had a negative impact on net interest margins both via the reduction in interest rates and –less powerfully- the flattening of the

Jointly estimate this entry game with several outcome equations (fees/rates, credit limits) for bank accounts, credit cards and lines of credit. Use simulation methods to

In our sample, 2890 deals were issued by less reputable underwriters (i.e. a weighted syndication underwriting reputation share below the share of the 7 th largest underwriter

—por lo menos inmediata— dependerá del resultado de la contienda en una u otra dirección —fascista o antifascista—, así la sociedad futura dependerá de los valores materiales

Thus, considering the increase in the number of prevalent and incident cases of PCa, the importance of the assessment of HRQoL of patients during the PCa diagnostic process,

When analyzed for its diagnostic value in this cohort of 9 patients and 10 controls, the levels of ANXA2 biomarker were found increased in complete plasma samples from

The second part proposes set- based fault detection and isolation for actuator and sensor faults, which is involved in interval observers and invariant sets.. In the second part,

Flt2sch reads a fault diagnostic file ( .dia ) created by the HILO fault simulator and produces Schedit command files (with a .flt extension), one for each schematic file,