• No se han encontrado resultados

Application of passive thermal energy storage in buildings using PCM and awnings

N/A
N/A
Protected

Academic year: 2017

Share "Application of passive thermal energy storage in buildings using PCM and awnings"

Copied!
183
0
0

Texto completo

Loading

Figure

Table 13. Climatic zone according to the CTE classification.
Figure 55. View of the concrete cubicles (2006).
Figure 57. View of the cubicles with awning; July 30 th, 2008 at 13:30 pm.
Figure 59. Instrumentation: heat flux sensor (left) and temperature sensor in the middle of the cubicles (right)
+7

Referencias

Documento similar

The purpose of this paper is to describe and assess a physically-based load model of residential Electric Thermal Storage (ETS) device, analyzing the possibilities of

degradation observed in CTRL samples during storage was greatly reduced in both 648.

Carrot smoothie preparation, heat treatment and storage conditions 118.. Carrot smoothie was prepared in a food processor (Robot Cook ® , Robot Coupe,

storage, no significant differences were observed between the lycopene contents at day 0 after the treatments and at 25 days of storage, with the samples pasteurized for 40

Convection heat loss from cavity receiver in parabolic dish solar thermal power system: A review. Application of phase change materials for thermal energy storage in concentrated

With this thesis we make several novel contributions to storage research: first we design and evaluate a pseudo-randomized distribution strategy that can adapt to hardware changes

In this work, nanofluids based on tungsten disulphide (WS 2 ) nanosheets have been prepared from the thermal oil currently used as heat transfer fluid in Concentrating Solar

A web application for the semi-automatic extraction and storage of information was developed, for extracting (digital and scanned) text, and for indexing, searching and storing