Revista Ingeniería Investigación y Tecnología | Facultad de Ingeniería UNAM

% IL in MG reduced one order the magnitude the wear rate of steel disk, with respect the commercially wind turbine gearbox lubricant.. Under the loads studied, the lowest wear

In this work the wear behavior of deep cryogenically treated (DCT), low-carbon AISI 420 martensitic stainless steel specimens has been studied with respect to that

Head hardened pearlitic steel grade (P2) has exhibit better wear behaviour than the pearlitic conventional one (P1), because of its higher hardness and yield strength,

Figure 41: Phase’s space diagram for a test at an angular velocity of 19.36 rpmm Figure 42 shows phase’s plane diagram corresponding to a test at an angular velocity of 14.86

In the evaluation of pipes of carbon steel used for the supply of potable water are detected structural problems in the SAE 1018 carbon steel, with which were manufactured

In this work the design of a system for controlling and monitoring corrosion occurring in SAE 1018 carbon steel pipelines carrying potable water at a region of Hidalgo

Figure 3 and Figure 4 present the Nyquist diagrams of low carbon steel AISI 1018 registered in the model acetic solution, in the presence of kerosene (hydrocarbon), through

Apostolopoulos [36] tested under laboratory conditions a steel alloy (S500s, Tempcore), to study the effect of the strain level and the corrosion duration on the number