Chemical bath deposition route for the synthesis of ultra thin CuIn(S,Se)2 based solar cells
Texto completo
Figure
Documento similar
Also, simulations of a dynamic information-based control model for route selection were performed and compared to results of participants using a haptic device.. Results of
While the spectra of the main secondary phases still overlap with CZTSe in some cases, the greatest advantage is the ability to use different excitation wave- lengths, which
Hydrogenated amorphous silicon is presented as a suitable material for application in solar cells and Hot-Wire Chemical Vapour Deposition is introduced as a viable technique for
[independently used by Puls 1987, for the case of a large number of overlapping lines, in the context of NLTE wind modeling/spectrum synthesis]. emergent profiles with S=J̅ ,
Highest ef ficiencies for CZTS cells reported up to this date have been deposited via a process first reported by Shin et al in 2013 using co-evaporation of the elements at low
Crystallite size and micro-strains calculated with the variance method 252 from the XRD diffraction data of the 111 perovskite reflection for the diol sol-gel derived PCT0 (a) and
In samples 1 and 3, the initial Na content in the absorber layers diffuses towards the surface as in the case of sample 2, but also the high temperature raises the Na
Figure 5.5: Difference in the EADS a) for pristine and b) for photooxidized KP115:PCBM thin films. Figure 5.6: Charge transients KP115:PCBM solar cells a) at different