• No se han encontrado resultados

Interaction between AVR reactive power control and high power AC-DC converter control as possible cause of instability

N/A
N/A
Protected

Academic year: 2017

Share "Interaction between AVR reactive power control and high power AC-DC converter control as possible cause of instability"

Copied!
1
0
0

Texto completo

Loading

Figure

Fig. 1.  500 kV and 330 kV transmission systems. Pre-fault power flow: Saturday 22:20, June 7th, 2008

Referencias

Documento similar

The simulation results show a reduction of around 25% in total power loss, a reduction of around 40% in the maximum junction temperature increase above ambient

The dc-ac inversion stage along with the DT-AFC control has been used to feed a load that presents complex dynamic behavior while generating ac output voltages at 48, 50 and 52 Hz.

In this paper a current sensorless control method of power factor correction for a boost converter based on pre-calculated duty cycle values is proposed, which is similar to

This study revealed that the use of a continuous semi- industrial MW, using high power/short time doses, could reduce food processing time, increasing the

method studied, using high power combined with short processing time, could be 342. recommended as an emergent pasteurization technique for maintaining quality of

Microbial counts (log CFU g -1 ) in unheated (control), conventional (CP) and microwave (MWP; high power/short time and low power/long time doses) pasteurized

Thus, taken together, these results sug- gested that these parameters could be considered as potential markers to differentiate between control (Chl, protein content, and Pro) and

Figure 5 shows an extended block diagram by including wind power generation frequency control (∆P WFs ) and demand-side contribution to PFC and SFC considered in Area 1 (∆P DS SFC