Raman and Ellipsometric Investigation of 570 nm CdTe thin film layer deposited by RF-Sputtering system
Texto completo
Documento similar
The friction torque in rolling bearings produced by these greases was measured and the coefficients of friction under boundary and full film lubrication were numerically
Two series of coatings (using two different peak powers) were deposited with increasing V content, in order to evaluate the effect of V addition on the surface and cross
The 1D heterostructures are microfabricated by optical lithography on a continuous 80 nm thick film of polycrystalline Co sputtered on glass. Both the patterned and the flat
12 Cross-sectional SEM micrographs and the surface morphology of CZTGS thin films show that the annealed-samples coming from the evaporation process Flash 3
7 and 8 is attributed to five main factors: (1) Reduction in the recombination rates by improving surface passivation, (2) improved light trapping by the use of TiO 2 thin film
So the flux of reflected plasma particles in the case of oxygen plasma is expected to deposit more energy onto the substrate than in the case of argon plasma, thus promoting
[22] who reported the influence of Nd doping on several properties of NZO films deposited on Si (1 0 0) by spray pyrolysis, showed that the samples exhibit ferromagnetic properties
organic, c-Si and CdTe (thin-film) emphasizing that the selection of an optimal combination of geographical location where the modules are manufactured and where the