• No se han encontrado resultados

Preparation and characterization of catalytic membrane reactors

N/A
N/A
Protected

Academic year: 2020

Share "Preparation and characterization of catalytic membrane reactors"

Copied!
14
0
0

Texto completo

Loading

Figure

Tabla 1.  Catalytic Membrane Reactors (CMR)
Figure 2 shows a TEM picture of the corundum  Hollow Fiber Membrane without catalytic phases
Figure 3: a) Pieces of PdFeCe measured at four points, two on the inner and two on the outer surface
Figure 4: Picture of palladium nanoparticles by impregnation, sputtering, microemulsion and palladium copper  nanoparticles and the size distribution
+2

Referencias

Documento similar

1.6 Recombinant production in E.coli and characterization of the proteolytic activity of different constructs of the Catalytic Domain of USP28 and USP25 with

Carbon corrosion is considered as a major cause for meso- and macroscale loss in performance. Further, the corrosion can also lead to the dissolution of active sites,

This section presents a brief introduction to the physics of uorescence on the nanoscale, and considers the most relevant topics for understanding the results obtained from the

Of special concern for this work are outbreaks formed by the benthic dinoflagellate Ostreopsis (Schmidt), including several species producers of palytoxin (PLTX)-like compounds,

Different catalytic membrane reactors were successfully prepared to be used in a novel approach to treat water pollutants. In this work they were tested with model compound

Characterization of the thermal contacts between heat exchangers and a thermoelectric module by impedance spectroscopy (under

Click here to view linked References.. The most important point defects and defect complexes have been explored and intrinsic defect formation energies were determined [21]. To

From this point of view, this thesis has a very broad scope focused on each and every one of the stages required to fabricate the high quality nanoelements studied: (i) the growth