• No se han encontrado resultados

Caracterización microestructural y comportamiento tribológico de aleación ti6al4v anodizado

N/A
N/A
Protected

Academic year: 2020

Share "Caracterización microestructural y comportamiento tribológico de aleación ti6al4v anodizado"

Copied!
11
0
0

Texto completo

Loading

Figure

Table 1.Anodizing conditions of Ti6Al4V ELI samples Anodizing time Current
Figure 1 shows the curves of potential as a function  of anodizing time in 0.3M H 3 PO 4  solution for 15,  45 and 90 minutes with current densities of 10 and  15 mA/cm 2
Table 2.  Localized chemical composition measurements of the anodized surfaces (EDXS) and  Pore size of anodic oxide films.
Figure 4. Surfaces Roughness parameters Ra, Rq and Rsk of anodized samples.
+4

Referencias

Documento similar

The draft amendments do not operate any more a distinction between different states of emergency; they repeal articles 120, 121and 122 and make it possible for the President to

The idea of the proof is the implementation of the infinite dimensional Implicit Function theorem to F around the initial solution F (0, V 0 , 0) = 0 (in the case of = 1), and

For a better comprehension of the results obtained, Figure 7 shows the conversion/emission nitrogen oxide values together with the photocatalytic NO X abatement

This results shows that to measure the proximity effect using the present experimental configuration, the sample should hold following conditions; (1) graphene layer lying on a

The lower panel shows a plot of the intensity of the light scattered by a sample of superparamagnetic nanobars of manganese-iron oxide as a function of the angle of orienta- tion of

Figure 1 shows the detection time and the energy of neutrino event candidates passing the reduction cuts for GW150914 (left) and the energy spectrum of the remaining events, which

Figure 3 shows the evolution of the uncertainties in the background prediction, before the fit to the invariant mass distribution described in section 8, as a function of m γγ in

Propagation 35–37 method, ADMP, as implemented in the Gaussian09 Package 38 (see Methods). Figure 3a shows the calculated number of trajectories as a function of the migration time