Mechanical Study on Al based Composites Synthesized by Mechanical Milling and Hot Extrusion

We compare the mechanical properties of fibers made of polymers and of composites with pristine single-walled carbon nanotubes (SWNTs), mechanically interlocked

The optimization is focused on the reduction of EM mass, and both displacements and stresses responses under the excitation of mechanical vibration due to the engine operation..

The typical solutions to improve the fracture behavior of alumina coatings are based on mixing alumina powders with other ceramic powders with superior

The aim of this study is to investigate the effect on the physical and mechanical properties of four different types of mortars after exposure to a sulfuric acid attack: (i) a

Effect of freeze-thaw cycles on the mechanical behavior of geopolymer concrete and Portland cement concrete containing micro-encapsulated phase change materials.. Shima Pilehvar a,b

Among them, a solvent-based chemical treatment that effectively dissolves Ultem™ 9085’s support material with minimal impact on the model material’s mechanical performance; the use

This study employs a test protocol based on a 3-point bending DMA (Dynamic Mechanical An- alyzer) configuration to assess the influence of the type of filler and the bitumen

Abstract: Transepidermal water-loss (TEWL), stratum-corneum hydration (SCH), erythema, elas- ticity, pH and melanin, are parameters of the epidermal barrier function and