Meshed low voltage distribution system planning with special reliability standards
Texto completo
Figure
Documento similar
The power processing circuit (PPC) created by the evolutionary algorithm is connected on one side to an input voltage source V in , and on the other side to an output circuitry made
The proposed strategy combines the active method to improve the vector control strategy in order to limit fault in current at low voltage dips and the passive method
Figures 12 and 13 present the GSC control strategy response to a three-phase voltage sag (0.1 pu) using the PR regulators under a full nominal power and a half nominal
A. Shortcircuits and Faults to ground. The most common cause of voltage sags are shortcircuits and faults to ground. These cases lead to the more severe voltage falls and to most
The dijet-mass distribution observed in data (points with error bars) and expected (histograms) with the Medium and Tight b-tagging categories (also referred to as MM and TT in
On the other hand, random connection topologies also give rise to high flow yet they have high construction cost and low transmission reliability.. Finally regular topologies show
For both the free liquid slabs and the adsorbed films and despite of the low vapor density, we have found that the fluctuations associated with the evaporation of particles to the
An improvement was explained in Flexible Area considering a function between open circuit voltage and maximum power point voltage when the temperature changes and other