When the communication is normally done
When the communication is not normally done Previous notice antenna/ETC
Voice guide The toll fee is notified.
2
When you drive
Knowledge - About the notification sound
It is likely to be notified two times at one ETC gate when the communication is normally done by the road side system.
- About the road equipment
- It is set up forward, and the previous notice antenna communicates with the ETC unit, and is an antenna of the toll gate to notify those who drive beforehand whether the ETC gate can be used through the ETC unit.
- When it is set up forward, and it communicates with the ETC unit, and the ETC card of the toll gate has not been inserted in the ETC unit correctly, the ETC card uninsertion information antenna is an antenna to notify those who drive beforehand through the ETC unit.
- Neither the previous notice antenna nor the ETC card uninsertion information antenna might be being set up by the system on the road side in the case to be set up.
- When you run without inserting the ETC card
The bitter orange lamp will blink, and we inform you by the voice "Feep *1 ..cannot the use of ETC.." when the information the previous notice antenna and the ETC card uninsertion antennas are passed while ..ETC card.. uninserted. This is the one to notify the ETC system not to be able to be used, and no breakdown of the ETC unit.
- In the navigation system installation car of one manufacturer option, it
becomes a voice "Porn ETC gate cannot be passed" or "Porn ETC card has not been inserted".
- About the notification of the toll fee
- The notified toll fee might be actually different according to the discount etc.
- When other Nabis guides etc. and coming in succession, the toll fee might not be guided. - 2
- Navigation system installation car of two manufacturer option
Attention - Attention when running
- Those who drive must not look at the lamp display of the ETC unit while running.
- Please decelerate enough when the ETC gate goes into it.
- Please run according to the guide displayed in the vicinity of the ETC gate when you pass the ETC gate.
- Please follow the toll gate clerk in charge's instruction when the opening and shutting bar at the ETC gate doesn't open.
- Additionally, please follow use that the road entrepreneur issues.
- Please pass over the ETC gate (for exit/adjustment) or the examination of tickets place with the ETC card used at the ETC gate (entrance).
- Please do not pull out the ETC card in the vicinity of the ETC card uninsertion of the information antenna, the ETC gate, the examination of tickets place, and the previous notice antenna. Data in the ETC card might be damaged.
2
When you drive
Confirmation of use history
The use day and the toll fee of the tollway can be confirmed by the voice.
When the ETC card is inserted while stopping, and a green lamp lights, it is possible to use it.
[Wo] is pushed.
The latest use history is guided.
When the history goes back, repeated is pushed.
It changes into an old use history whenever pushing.
The following of the most past history return to the latest history.
After about one second or more after the guide ends The latest use when pushing [wo]
It is guided from the history.
Knowledge
- About the use history
- Because the use history is recorded on the ETC card, the record number is different according to the ETC card used. (100 or less)
- When the maximum record number of use histories is exceeded, the oldest use history is deleted.
- It is guided , saying that "There is no use history" when there is no use history.
- When information on the use day is not correct, it is guided , saying that "The use date is uncertain".
- When information on the toll fee is not correct, it is guided , saying that "The charge is uncertain".
Attention - Attention when using it
Volume adjustment
Volume large volume smallness
The adjustment result is guided by the voice.
Confirmation of recorded union error code
The ETC unit records union error code ( P. 165) generated
Volume Voice guide
1 . 8 "Volume **. "
0 "The voice guide is discontinued. "
Knowledge
- About the volume adjustment
- The volume adjustment is effective for the following guides. ･ Notification unset up
･ Buzzer sound when error occurs
･ Forgetting to pull out card warning
･ Confirmation of use history
･ Guide when volume is adjusted
- When the error occurs even if the voice guide is set to discontinuance (volume 0), it is output by volume 1.
- When the ETC unit is muffled (volume 0), the notification t h a t t h e E T C u n i t u n s e t s u p i s n o t o u t p u t .
2
When you drive
Union error code list
We will inform you of the union error code (The error 01 - 07) by the voice with the outline of a subject when the error occurs while using ETC.
Please deal respectively according to the following table.
Union error
code Content of abnormality Cause of abnormality Coping process
01 The ETC card insertion is abnormal.
･When communicating, the ETC card has not been inserted.
･ State of insertion of ETC card However, [warui].
Please insert it again after confirming the insertion of the ETC card.
02 Data processing is abnormal.
･ Reading [da] to ETC card It does, and it makes an error writing. ･ ETC card and ETC [yu]
Defective point of contact of knit (instantaneous interruption accessing ETC card)･
When being reading it, it is writing it.
Eject of card
When ETC card is inserted The data of the inserted ETC card was not able to be read. Please insert it again.
Please inquire of the Toyota shop when the error doesn't cancel it.
Before passing the ETC gate:
The stop of the vehicle might be guided in the toll gate. Please follow the toll gate clerk in charge's instruction after the vehicle stops.
After passing the ETC gate:
The stop of the vehicle might be guided in the following toll gate. Please go into a general lane (ETC/in general common lane is contained) where the toll
Union error
code Content of abnormality Cause of abnormality Coping process
03 The ETC card is abnormal.
･ The ETC card breaks down and [i].
[Ru]
･ Cards other than IC card It is inserted, and it doesn't communicate.
･ Wrong insertion of ETC card (difference for the back and insertion)
It was not able to be recognized that the inserted card was ETC card. It is correct Please insert it again after confirming the ETC card, and the direction etc.
of insertion.
Please inquire of the Toyota shop when the error doesn't cancel it.
04 ETC unit
breakdown
As a result of the self-diagnosis, it was judged the breakdown of the ETC unit.
Please start the engine again.
Please inquire of the Toyota shop when the error doesn't cancel it.
05 Abnormality of ETC card information
･ Attestation error with ETC card
･ IC cars other than ETC card [Do] inserts it.
･ [I] of ETC card when being attesting it [Jekuto]
･ With the unsetup Insertion of ..ETC.. card drinking
It was not able to be recognized that the inserted card was ETC card. It is correct Please insert it again after confirming the ETC card, and the direction etc.
of insertion.
Please inquire of the Toyota shop when the error doesn't cancel it.
06 Abnormality of ETC unit information
Attestation error with road side wireless device
The error occurred in the data processing between the ETC unit and the toll gate.
Please follow the toll gate clerk in 07 Communication abnormality
The communication with a road side wireless device ended on the way.
2
When you drive
Knowledge
- In this case, it is not abnormally.
- No breakdown of the ETC unit though might notified union error code (07) when communicating with the ETC card uninsertion information antenna etc.
- A wireless communication of the ETC unit is used, and the parking management system etc.
are operated. No breakdown of the ETC unit though might notified union error code (01) or (07) when a communication different from the charge payment of the tollway is done.
- When the error occurs after passing the ETC gate
The error sound stops when the ETC card is pulled out. Again, when the ETC card is inserted, the stop of the vehicle might simultaneously be guided with the voice of "Porn ETC card was inserted" in the following toll gate though a green lamp lit.
Warning
- Thing not piled up
It might ignite if the following things are piled up and is dangerous.
- Container that fuel entered - Spray can - When loading with luggage
- Please do not load the following places with luggage.
Luggage might correctly be not able to operate, interrupt view, collide with the crew luggage, and cause an unexpected accident the brake gas pedal if it doesn't guard. ･
One's driver's seat feet
･ Passenger's seat and rear seat (When you pile luggage).
･ Package tray
･ Instrument panel
･ Dashboard
Please guard the following when loading with luggage to do a safe, comfortable drive.
- The trunk is loaded with luggage as much as possible.
- Whether it is put on the position where luggage is safe is confirmed.
- So as not to bias weight, it piles up to maintain the balance under running.
- To prevent fuel cost from deteriorating, unnecessary luggage doesn't pile up.
2
When you drive
Warning
- About how to apply weight and the load of luggage - Please do not load with luggage too much.
- Start always be being even the load.
This not only is put a strain in the tire but also is caused an unexpected accident due to the decrease in the steering wheel control and the brake control, and is received important injury or, in the worst case, might lead to the death.
Please drive appropriately after the preparation and the check, etc. are correctly treated in preparation for the cold.