Conexión de Alcantarillado y Apertura de Calle

**********TEST ALARM IN IOG BSC'S****************** ALLTI:ALI=0;(INITIATE)

ALLTE:ALI=0; (END)

************* CELL CONNECTING TO MSC**************

MGOCI:CELL=12345,CGI=424-4023(LAC)-61701,MSC=X23; (FOR OUTER CELL) MGCEI:CELL=12345,CGI=424-4023(LAC)-61701,MSC=X23; (FOR INNER CELL) ****************** checking BSC CALL LOAD*****

******************* IO BLOCKED*****************

ALLIP:ACL:A2; CHECK WHICH IO BLCOKED THEN BLOCK & DEBLOCK IOBLI:IO=AT-5;

IOBLE:IO=AT-5;

************************* HOW TO CHECK UMTS SITE ***************** RNC=41 TOTAL WORKING SITES =32

TOTAL WORKING CELLS=94

TOTAL AVAILABLE CELLS=136 -- 36 SITES NOT WORKING RNC=42 TOTAL WORKING SITES =31

TOTAL WORKING CELLS=83

TOTAL AVAILABLE CELLS=89 -- 6 SITES NOT WORKING ACT CELLHSDPA ( TO ACTIVATE HSDPA)

DEA CELL (HALTED SITE DEACTIVATED) ACT CELL (ACTIVE CELL)

RST DSP( RESET DSP) IN ONE WFMR WE HAVE 16 DSP ,REV1&2 DSP BRP(CHECK BOARD)

DSP CELL (DISPLAY CELL) DSP IMALNK(DISPLAY IMLINK) TO CHECK LINK DSP E1T1 RNC-41 USER NAME=ALI P= ALI123

RNC-42 USER NAME = ADMIN PASS = ETSUMTSRNC42 LOOP BREAK:

CONNECT TO RNC & THEN

1-LST NODEB (GET SITE DETAIL e.g U4060 & THEIR SERIAL #, SUBORD& SLOT) 2- LST NODEB AGAIN (BY NODEID & PUT SER #, & VERTICAL,& GET IMA LINK NUMBER)

2- DSP E1T1 (PUT SUBRACK NO ,SLOT, & IMA LINK NUMBER E.G 31,32,33) ---HOW TO KNOW RNC 19 ADDRESS FOR IP BASED INTERMITTENT FAILURE---

CONNECT TO RNC THROUGH MML

LST NODEB (BY NAME CHECK SUBRACK & SUBSYSTEM)

LST ETHIP (CHECK WITH PORT 0&1 SUBSYSTEM 0 PORT 0 & SUBSYSTEM 1 PORT 1) GIVE THAT IP ADDRESS I.E LOCAL IP ADDRESS IS ADDRESS OF CURRENT RNC IP OF SITE

************************ TRANSMISSION STM OUTAGE **********

FIRST OF ALL TAKE ALLIP; FOR BSC WHICH IS STM CHNAGE OVER THEN AFTER FINISH ALLIP

AGAIN TO CHECK ANY ABNORMAL ALARM THEN CHECK STM IN BSC

PWNSP:SDIP=ALL; (SHOWS STATUS WHICH ONE STANDBY OR ACTIVE ) PWMSI:SDIP=2ETM2,MS=MS-1; ( TO MAKE STM -MS-O OR 1 ACTIVE)

THEN IN LAST DO TPQSR FOR PARTICAULAR STM WHICH HAS CHNAGED OR SOME OUTAGE

*** CLEARING SOFWARE ERROR *** allip:acl=a2;

syrae:rectype=softerr;

********************** HOW TO KNOW DEVICES CONNECTED TO SITES RXMDP:MOTY=RXOTRX;

RXMDP:MOTY-RXOCF; RXMDP:MOTY-RXOTS;

IF RANGE NOT IN CF OR TRX THEN FIND IN TS RADRP:DEV=RHDEV-1254;

FCRWS:RP=XX,WS=SEP; BLPRE:RP=125;

******************* CHANGING DIVERSITY**********************

CHANGING DIVERSITY IF WE HAVE 1 ANTEENA AND DIVERSITY IS DEFINED AB e.g RXD=AB TO CHANGE TO RXD=A

HALT SITE FIRST

rxesi:mo=rxotrx-3-0,subord; (BRING OUT OF SERVICE ) RXMop:MO=RXORX-3-0&&-11; (CHECK RXD=AB OR A )

RXMoc:MO=RXORX-3-1,rxd=a; (CHANGE RXD=A OR AB) THEN DEBLOCK , BRING INTO SERVICE & ACTIVATE AGAIN

RXMop:MO=RXORX-3-0&&-11; ( NEW RXD WILL BE CHANGED) ********************* CHANGING CONFACT********

FIRST HALT SITE,BLOCK TG WIL SUBORD,BRING OUT OF SERVICE, THEN CHNAGE CONFACT

RXBLI:MO=RXOtg-70,subord,FORCE; rxesE:mo=rxotg-70,subord;

rxmop:mo=rxotg-70; (WHICH CONFACT CHECK VALUE ) rxmoc:mo=rxotg-70,confact=3; (CHNAGE VALUE) ; rxesi:mo=rxotg-70,subord; RXBLE:MO=RXOtg-70,subord; ACTIVATE SITE ************* HANGED ALARM IN BSC********* CHECK IOSTP;

IF SOME DEVICES ARE WAITING THEN ALARM IN HANGING INVESTIGATE WHICH AT TERMINAL IS HAVING PROBLEM

THEN EXCUTE COMMAND TO RELEASE ALARM iostp

clear those devices which are seized not of waiting status

IOREI;

IOREI:SIZIND=1,IO=AT-0; IOREI:SIZIND=1,IO=AMTP-12;

if NOT ACCEPTED FAULT CODE 172 INDIVIDUAL NOT OCCUPIED then IOREI:ioIND=H'9002; (take H'9002 ) FROM TOP

***************CDU SWAPPED***********

E-GSM FREQUENCIES NEED CDU WITH ARTICLE CODE BFL-****135, DIGITS 135 IS ESSENTIAL, IF CDU SWAPED AND TRX NOT COMING UP IT MEANZ THAT CDU NOT SUPPORT E-GSM FREQUENCIES, SO REVERT BACK CHNAGES AND BESURE

ARTICEL CODE 135 WITH ATTAHED TO THOSE TRU WHICH IS HAVING E-GSM FREQS ******************* DISTRIBUTED GROUP SWITCH FAULT ************** allip:acl=a2; gdcop:unit=MUX3-A-12; exrpp:rp=206; exemp:rp=206,em=all; gdblI:unit=MUX34-A-3; gdTEI:unit=MUX34-A-3; gdblE:unit=MUX34-A-3; ********************* LVA DIFFERENCE***************** RLSlC:CELL=20973,lva=60,sctype=ul,chtype=tch; (FOR A2)

RLSlC:CELL=20973,lva=26,sctype=ul,spv=2,chtype=tch; (FOR A1,TCH FR =2) ***************** HOW TO CONNECT TG TO CELL******************

RXTCI:MO=RXOTG-38,CELL=40522,CHGR=0; RXTCP:MOTY=RXOTG,CELL=40522;

CONNECTING TG SING VALUE GIVEN BY PROJECT RXMOC:MO=RXOTF-38,TFMODE=S,TFCOMPNEG=4638; DISCONNECT TG

RXTCE:MO=RXOTG-38,CELL=40522,CHGR=0; CONNECT TG TO RBLT

RXAPI=MO=RXOTG-XX,DEV=RBLT-Y&&-K,DCP=1&&((NT+1)*3); CHANGGING BAND 900 TO 1800 OR VISE VERSA

FIRST BLOCK ALL TRX WITH SUORD RXMOC:MO=RXOTRX-13-8,BAND=GSM1800; DO IT ON TX THEN RX

CHANGING ALLOCATION FROM ONE CHGR TO OTRHER RXMSC:MO=RXOTRX-20-4,CELL=4162,CHGR=1; ************* MSC DEFINITION IN BSC DATA rrmbp:msc=all; output MSC DEFINITION IN BSC DATA MSC SP CNID X13 2-548 END

********************** REDUCE SDCCH RLCFP:CELL=4201; (FIND HOW MANY SDCCH) THEN

RLCCC:CELL=4202,SDCCH=8,CHGR=0; IN WHICH CHRR IS THERE

************************ NETWORK SYNCHRONIZATION FAULT PWNSP:SDIP=ALL;

NSBLI:SDIP=4ETM2,MS=MS-0; NSTEI:SDIP=4ETM2,MS=MS-0; NSBLE:SDIP=4ETM2,MS=MS-0;

*******************SITE UP NOT STILL SHOWING IN ALV********** THIS COMMAND WORKS

RLSLE:CELL=41251,SCTYPE=UL; RLSLI:CELL=41251,SCTYPE=UL;

THEN CHEC STATE OF CELL SHOULD BE YES **************** IOG BSC RESTART********* SMALL RESTART IMMCT:SPG=0; IMCSP; END; SYRSI:NODE=B,RANK=SMALL,SPG=0; LARGE RESTART CP OR BSC RESTART- SYREI:RANK=LARGE,EXPL=OTHER-"CPA2_IPA13"; ************** STM DOWN FOR SITE ******** TPCOP:SDIP=ALL;

OR IF STM KNOW THEN TPCOP:SDIP=1ETM2;

CHECK WHICH RBLT 23 WHICH VC VAKLUES THEN TPSTP:SDIP=1ETM2;

************ SW UPGRADE ******************** COMMANDS TO CHECK THE BTS SW IN BSC

INMCT:SPG=0;

INFIP:FILE=B440R014L; END;

COLLECT TG ALL IN BSC &

RXMOP:MO=RXOTG-242; TO CHECK WHICH VERSION RUNNIG RXTCP:MOTY=RXOTG,CELL=38960;

rxmop:moty=rxotg; (TELL ALL TG IN BSC)

rxmsc:mo=rxotg-229,swver=b4404ro14l;

AFTER GETTING DATA FROM CHA OF ALL BSC TG RUN THIS COMMAND IN OPS IN ONE TIME

THEN ONCE ITS OVER RUN RXPLI:MO=RXOTG-1,UC;

THIS RUN IN CHA AND MAXIMUM NUMBER OF TG ARE 16 OTHER INFORMATION IS WRITTNE IN NOTE BOOK

******************** SDCCH ADDITION *********** rlslp:cell=27781; rlcfp:cell=27781; RLCCC:CELL=23541,SDCCH=8,CHGR=0; RLSLC:CELL=23541,CHTYPE=tch,LVA=24,SCTYPE=UL; RLCCC:CELL=51641,TN=2&3,CHGR=0; RLCHC:CELL=27481,CHTYPE=SDCCH, ***********************ADJUSTING CHA RLSLC:CELL=46283,CHTYPE=TCH,LVA=83; ************************* MISMATCH BTSPOWER********** CHECK TX POWER BY RXMOP:MO=RXOTX-203-0&&-11 THEN RLCPP:CELL=42441;

IF TX POWER IS 47 & CELL POWER IS 40 ,CHNAGE CELL POWER TO 47 ONCE CELL UP REVERT BACK

RLCPC:CELL=42441,BSPWRB=40,BSPWRT=40;

************ GB INTERFACE FAULT OR GPRS LINK FAILURE ****** METHOD TO REPORT TO TEMC

check with rtglt down rtglt0 or 1

then take in which stm it is working then booke with TMC AND GIVE KLM VALUE ALSO

FORMAT

IF NSVC-1 = BSCN9-RTGLT1 - UP2-3002 NSVC-0 = BSCN9-RTGLT0 - UP2 - 3001 (10ETM2-KLM 353)

DTDIP:DIP=RTGLT1;

TPCOP:SDIP=ALL;(CHECK WHICH STM CARRYING RTGLT 0 OR 1 ) DTDIP:DIP=RTGLT1;

NTCOP:SNT=ETM2-9;

************ DEBLOCKING THE TRANSCIEVER RHSNT****** NTCOP:SNT=ALL;

NTCOP:SNT=RHSNT-23; (SNT STATUS)

STDEP:DEV= RHDEV-5888&&-5919; (CHECK WO & MBL DEVICE RANGE ) BLODE:DEV=RHDEV-5888&&-5919;

(DEBLOCKING & THEN CHECK STDEP MUST BE IDLE OR BUSY) EXDAI:DEV=dev...;

BRINGING INTO SERVICE

************* PCM LINK BLOCKING RALTS *************

SWITHCING WILL GIVE US ONLY PCM NO SO WE HAVE TO TAKE OUT DEV RANGE OF THAT RALT AND BLOCK.

E.G PCM NO 3006 IT WILL BE -1 RALT 5