• No se han encontrado resultados

RESULTADOS DE LAS OPERACIONES EFECTIVAS:

Nota 20: Cuentas de Resultado Acreedoras

III. RESULTADOS DE LAS OPERACIONES EFECTIVAS:

Intrastate Authority: Sammons does not have intrastate authority in South Dakota. SOUTH DAKOTA O/D PERMITS INFORMATION PERMITS: Permits valid for three days. Must have permit prior to entering the state.

OPERATING TIME: One-half hour before sunrise to one-half hour after sunset, including Saturday and Sunday. Loads not exceeding 10' wide, 14'6" high, 110' overall length may travel on interstate highways continuously and within a 2- mile radius of Interstate Highway interchanges on state highways. Loads that are only overweight may operate 24/7.

LEGAL DIMENSIONS: Width: 8'6'' Height: 14''

Length: 53' semi-trailer, overall length not limited. Overhang: 3' front, 4' rear, or 53' trailer and load.

Poles, pipes, beams, utility poles, etc. are not exempt from permits for length or rear overhang. Weight: 80,000 Gross Single – 20,000 Tandem – 34,000 Tridem – 42,000 Steer Axle may not exceed 600 pounds per inch of tire width.

Divisible Loads Exceeding 80,000: You can exceed 80,000 gross without a permit on state highways as long as you are legal on all axle/group weights and you are licensed for at least the amount of your gross weight. However, if you need any Interstate route, you will need to get an "Interstate Permit."

ROUTINE PERMIT LIMITS:

Width: Depends on routes Height: Depends on routes Length: Depends on routes Weight: Single – 24,000 Tandem – 46,000* Tridem – 60,000* Quad – 68,000* Steer – 600 lbs. per inch of width (13,200 for 11" steers)

Register for at least the amount of weight you wish to permit, or pay extra for a trip permit. Some routes will allow more weight. SD will have to determine by route.

All axles must be on the ground when permitting for overweight load.

Tractor must be registered for weight hauled, or pay an extra fee for the trip with the permit order. ESCORTS:

Width: On Interstate Highways: Over 16' – 1 escort. On most State Highways: Over 20' – 1 escort. Multiple escorts are required if the load extends more than two feet into adjacent driving or passing lanes, or if traffic cannot pass without the permitted vehicle or passing vehicle driving on the shoulder of the road.

Black Hills area, except on US16 from Rapid City to Keystone, WY & US 18: over 10' – 1 escort. Length: Over 130' – 1 escort

Height: Normally no requirements.

SEASONAL LOAD (WEIGHT) RESTRICTIONS: Spring thaw load weight restrictions may go into effect anytime after February 15th. Check with Permit Office.

SIGNS, FLAGS & LIGHTS: All overdimensional vehicles and loads must display flags. Flags must be attached to all corners of vehicles or loads wider than 8'6'' and to corners of any load extending beyond the width of the hauling vehicle. Flags are also to be attached to load projections exceeding 3 feet in front of the vehicles front bumper, or more than 4 feet beyond the rear of the trailer. If the front or rear projection is not wider than two feet, at least one flag is needed on the projection, and 2 flags are required on the projection if it is over 2 feet in width.

“Oversize Load” or “Oversized Load” signs are required front and rear on all permit vehicles that exceed a width of 12 feet or a length of 95 feet, or that operate during nighttime hours. Signs must be reflectorized when used for night moves. Signs must be covered or removed when they are not required.

Load projections must be lighted for nighttime running with amber lights, red lights, and reflectors. The specific requirements of nighttime lighting are listed on the South Dakota permit.

TENNESSEE

License/Prorate/Fuel: Tennessee is a member of the IRP and IFTA. The Tennessee fuel number HF49694 is included in/and part of your STC placards and is the only requirement.

Intrastate Authority:

TENNESSEE O/D PERMITS INFORMATION Permits: Permits valid for six days. Must have permit prior to entering state.

Operating Time: Daylight only (one-half hour before sunrise to one-half hour after sunset) Monday through Saturday. No travel on Sundays. Overweight only may have continuous movement.

Restricted Travel: Movements over 12'6" in width or 85' long or greater or will not be allowed within any statewide city limits and all heavily traveled adjoining commercial or residential areas between the hours of 7:00-9:00 AM and 4:00- 6:00 PM from Monday through Friday. No travel on major holidays. Check with the Sammons Permit Office.

Legal Dimensions:

Width: 8'6" Height: 13' 6"

Length: Not to exceed 50' from kingpin to end of trailer or load is legal length. A permit is required for utility poles when overall length is 75feet or more.

Overhang: See Length, above.

Weight: 80,000 Gross Single – 20,000 Tandem – 34,000 Tridem – 42,000 w/ 8' of spacing, 42,500 w/ 9' spacing

Routine Permit Limits: Width: 16' Height: 15' Length: 120'

Weight: 5 axles – 100,000 6 axles – 120,000 7 axles 140,000 Single – 20,000 Tandem – 40,000 Tridem – 60,000

Loads exceeding these dimensions are Super Loads. Generally, movements of over 16' wide or 15' high will not be permitted unless it can be proven that the movement is in the interests of public welfare, safety, or national defense. Movements over 16' high will not usually be permitted, and would require a letter of necessity describing the load and why it needed to go through TN to possibly get a permit.

Escorts:

Width: On Interstate and 4-lane highways: Over 12'6" – 1 escort, over 14' – 2 escorts.

On 2-lane highways: Over 10' – 1 escort (unless over 24' pavement width excluding shoulders), over 14' – 2 escorts. Height: Over 15' (if approved) – 1 escort with height pole

Length: Over 85' – 1 escort, over 120' – 2 escorts. (Over 75' to 85' long requires rotating or strobe type amber light).

MISCELLANEOUS: Bulldozer blades or loads with protruding sharp objects shall be loaded with the blade or protruding sharp object to the rear of the hauling equipment when the blade exceeds 10'6” in width. No permits will be issued for blades or protruding sharp objects creating width in excess of 13'6". Combination loads cannot be permitted for two overdimensions on two different pieces (example: cannot permit for a load with overwidth dozer and overheight backhoe on same load).

SIGNS, FLAGS & LIGHTS: All movements exceeding 10' in width and/or 75' in length require “Oversize Load” at front and rear. Loads over 75’ overall length but not exceeding 85’ require a rotating or strobe type amber light on the end of the load. Red flags are required on overwidth loads front and rear, and top and bottom each side where load is widest (or at the widest point if it is between the top and bottom). Red flags must be placed at the extreme rear end of overlength loads or when there is over 4' rear overhang. No sign or flag requirements are listed for overheight only loads. For overweight-only loads, you still need Oversize Load signs according to a scale officer, but the rules and regulations do not specify this.

TEXAS

Documento similar